Sntp Tab - Interface Settings; Figure 5-53: Sntp - Interface Settings - Linksys SRW2016 User Manual

WebView Switches
Last Response. This describes the last response of the broadcast server.
To add an SNTP server, click the paper and pencil icon. On the new screen that appears, you can configure the
following settings:
SNTP Server. Enter the IP address of an SNTP server. You can have up to eight SNTP servers.
Poll Interval. Enable this feature if you want the Switch to poll the SNTP server for system time information.
Encryption Key ID. Select the encryption key used to communicate between the SNTP server and Switch.
Click the Submit button to save your changes.

SNTP Tab - Interface Settings

The Interface Settings screen shows the SNTP settings for different interfaces.
Interface. This shows the interface on which SNTP can be enabled, either a port, LAG, or VLAN.
Receive Servers Updates. This shows whether or not updates are received.
To add an interface, click the paper and pencil icon. On the new screen that appears, you can configure the
following settings:
Interface. Select the appropriate interface, Port, LAG, or VLAN. Then select the appropriate number from the
drop-down menu.
State. If you want the interface to receive updates, select Enable. Otherwise, select Disable.

Figure 5-53: SNTP - Interface Settings

Click the Submit button to save your changes.
Chapter 5: Using the Web-based Utility for Configuration 57
SNTP Tab - Interface Settings