Linksys RVS4000 User Manual page 58

4-Port Gigabit Security Router with VPN
example, if you have a web server, you would enter the range 80 to 80. Click the Add to List button. Then
click the Save Setting button. Click the Exit button.
C. Enter the IP Address of the server that you want the Internet users to access. For example, if the web
server's Ethernet adapter IP address is 192.168.1.100, you would enter 100 in the field provided. Check
"Appendix E: Finding the MAC Address and IP Address for Your Ethernet Adapter" for details on getting an
IP address. Then check the Enable checkbox for the entry. Consider the examples below:
Application Start and End
UT 7777 to 27900
Halflife 27015 to 27015
PC Anywhere 5631 to 5631
VPN IPSEC 500 to 500
D. Click the Add to List button, and configure as many entries as you like.
When you have completed the configuration, click the Save Settings button.
8. I can't get the Internet game, server, or application to work.
If you are having difficulties getting any Internet game, server, or application to function properly, consider
exposing one PC to the Internet using DeMilitarized Zone (DMZ) hosting. This option is available when an
application requires too many ports or when you are not sure which port services to use. Make sure you
disable all the forwarding entries if you want to successfully use DMZ hosting, since forwarding has priority
over DMZ hosting. (In other words, data that enters the Router will be checked first by the forwarding settings.
If the port number that the data enters from does not have port forwarding, then the Router will send the data
to whichever PC or network device you set for DMZ hosting.) Follow these steps to set DMZ hosting:
A. Access the Router's Web-based Utility by going to http://192.168.1.1 or the IP address of the Router. Go
to the Setup => Forwarding tab.
B. Disable or remove the entries you have entered for forwarding. To delete an entry, select it and then click
the Delete selected application button. Keep this information in case you want to use it at a later time.
C. Click the DMZ Host tab.
D. Enter the Ethernet adapter's IP address of the computer you want exposed to the Internet. This will bypass
the NAT security for that computer. Please refer to "Appendix E: Finding the MAC Address and IP Address
for Your Ethernet Adapter" for details on getting an IP address.
Once completed with the configuration, click the Save Settings button.
Appendix A: Troubleshooting
Common Problems and Solutions
Protocol IP Address
Both 192.168.1.100
Both 192.168.1.105
UDP 192.168.1.102
UDP 192.168.1.100
Enabled
X
X
X
X
49