Linksys RVS4000 User Manual page 38

4-Port Gigabit Security Router with VPN
Local Security Group
Local Security Group Type. Select the local LAN user(s) behind the router that can use this VPN tunnel. This may
be a single IP address or Sub-network. Notice that the Local Security Group must match the other router's
Remote Security Group.
IP Address. Enter the IP address on the local network.
Subnet Mask. If the "Subnet" option is selected, enter the mask to determine the IP addresses on the local
network.
Remote Security Group
Remote Security Group. Select the remote LAN user(s) behind the remote gateway who can use this VPN tunnel.
This may be a single IP address, a Sub-network, or any addresses. If "Any" is set, the router acts as responder
and accepts request from any remote user. Notice that the Remote Security Group must match the other router's
Local Security Group.
IP Address. Enter the IP address on the remote network.
Subnet Mask. If the "Subnet" option is selected, enter the mask to determine the IP addresses on the remote
network.
Remote Security Gateway
Remote Security Gateway Type. Select the desired option - IP address or "Any". If the remote gateway has a
dynamic IP address, select "Any".
IP Address. The IP address in this field must match the public IP address (i.e. WAN IP Address) of the remote
gateway at the other end of this tunnel.
Key Management
Key Exchange Method. The router supports both automatic and manual key management. When choosing
automatic key management, IKE (Internet Key Exchange) protocols are used to negotiate key material for SA. If
manual key management is selected, no key negotiation is needed. Basically, manual key management is used in
small static environments or for troubleshooting purpose. Notice that both sides must use the same Key
Management method.
Auto IKE
Chapter 6: Setting Up and Configuring the Router
VPN Tab
29