Spm Configuration With Eddl - Emerson Rosemount 3051S Series Reference Manual

Reference Manual
00809-0200-4801, Rev DA
6.3.8

SPM configuration with EDDL

For host systems that support Electronic Device Description Language (EDDL), using SPM is made easier
with step-by-step configuration guidance and graphical displays. This section of the manual uses AMS
Device Manager version 10.5 for illustrations, although other EDDL hosts could be used as well.
The SPM Configuration Wizard can be launched by selecting Statistical Process Monitor Setup from
the Configure > Guided Setup page.
This wizard will take you step-by-step through the parameters that need to configure SPM. On the first
screen
Figure 6-7. SPM Configuration Wizard - Selecting the SPM
The wizard progresses through the process of setting the parameters corresponding to the Block Tag,
Block Parameter, Monitoring Cycle, and Bypass Verification.
Fieldbus hosts that support device dashboard functionality (e.g. AMS Device Manager 10.0 and later),
allow selection from a list of valid function and transducer blocks
manually enter the block tag. Once this parameter is selected, the SPM#_Block_Type parameter will be
determined automatically. For non-device dashboard hosts (e.g. AMS Device Manager 9.0 and previous)
you will have to manually enter the Fieldbus block tag that was assigned by the host system, and select
the Block Type.
Figure 6-8. Device Dashboard Supported Hosts can Select Function Block for SPM
z
Advanced Pressure Diagnostics
(Figure 6-7), select which SPM block (1, 2, 3, or 4) to configure.
Advanced Pressure Diagnostics
(Figure 6-8), rather than having to
October 2016
79