Iii-6 Port Mirroring - Edimax GS-5008E Manual

Item
LACP Global
State
Link Aggregation
Algorithm
Link Group
Activity
Link Group
Member
Apply
III-6 Port Mirroring
Port mirroring selects the network traffic for analysis by a network analyzer.
This is done for specific ports of the switch. You may configure the ports as
source ports or configure one of the ports is as a destination port.
Select "Enable "or "Disable" to enable or disable
Link Aggregation Control Protocol.
Select the outgoing traffic distribution type.
Packets from the same source and/or to the same
destination are sent over the same link within the
trunk.
By default, the Switch uses the MAC SA & DA
distribution type.
MAC SA & DA: To distribute traffic based on a
combination of the packet's source MAC address
and destination MAC address.
MAC SA: To distribute traffic based on the packet's
source MAC address.
MAC DA: To distribute traffic based on the
packet's destination MAC address.
Switch TX LACP control packet Passive or Active.
By default, the Switch uses the Passive mode.
The check box of ports would be checked after the
port is added into the Link Group successfully.
Click Apply to save your changes.
12
Description