Assembling The Start/Stop Control; Resistance Test - Stop Function - Husqvarna 555 Workshop Manual

6.7 Assembling the start/stop control

1
it the new stop control A and tighten screw
place at a torque of 1 Nm. Slide in the stop control
in the rubber slee e C and hook the slee e on the
guide taps. See gure 15.
2
Attach the cables as outlined in gure 16.
3
Attach the air lter holder. See the Assembling the
carburettor chapter.
4
it air lter and cylinder co er.

6.8 Resistance test - stop function

ismantle the ignition module as outlined in
7.7 ismantling the ignition module and ywheel .
Cut open the shrink tube co ering both cables and
shrink tubing that encloses the cable ends.
Clean the contact areas and check resistance in
the following way:
Test the resistance by connecting a multimeter to
the cable ends. N TE The power switch must be
in the on position to get the correct reading. See
gure 17.
The stop switch is in the on position when the
button is held down see gure 17 and in the off
position when the button is in neutral.
Resistance can be 0.5
switch in the on position.
When assembling see gure 18 , pull the cable
ends apart and slide on a thicker shrink tube o er
both cables. Then slide on the thinner shrink tubes
o er each cable. Connect the cable ends together.
Slide the thinner shrink tubes o er the cable ends
and heat the shrink tube rst on both cables sepa-
rately. Slide the thicker shrink tube o er the thinner
shrink tubes and then heat the thicker shrink tube.
hm at most with the power
in
ig 15
ig 16
ig 17
ig 18
Safety equipment
21
English -