Ismantling The Throttle Control Lock, Throttle Control And Spring - Husqvarna 555 Workshop Manual

Safety equipment
6.9 Dismantling the throttle control
lock, throttle control and spring
1
Loosen the screw on the rear handle. Remo e the
handle insert A . See gure 19.
2
Loosen the throttle control lock
gure using a screwdri er or similar tool. Remo e it
then from the shaft in the handle. See gure 20.
3
Press out the throttle control pin C with the help
of a punch. See gure 21.
4
Loosen the throttle cable
control and the spring. See gure 22.
5
Cleaning and inspection
Carefully clean and check all parts. See gure
13. Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
Check that the spring is intact and retains all its
•
tension.
22
- English
as shown in the
and lift out the throttle
A
ig 19
ig 20
ig 21
ig 22
ig 23