Assembling The Chain Brake - Husqvarna 555 Workshop Manual

Safety equipment

6.2 Assembling the chain brake

1
Screw the knee oint and the brake band together
see gure 5 using a tightening torque of 1-1.5
Nm. Place the knee oint with the tted chain brake
band in the opening in the clutch co er. The space
for the spring in the co er must be lubricated with
grease. See gure 6.
2
Compress the spring with a wide screwdri er and
press it down with your thumb. See gure 7.
WARNING!
Exercise care to ensure the spring
does not fly out and cause personal
injury. Wear protective goggles.
3
it the co er o er the brake spring using 1-1.5 Nm
tightening torque. See gure 8.
4
Tighten the brake by using the saw s hand guard
as a tool. Mesh with the brake and tighten clock-
wise until the brake is in the off position. See
gure 9.
5
N TE Make sure the bushings in the kickback
guard s attachments are kept in place from the
inside. See gure 9.
Screw the kickback guard in place and put the
rocket in position. Position the spring
plastic housing C see gure 10 and press the
spring against the rocker and then press the plastic
housing into its groo e. Tighten the chain guide
plate in place.
it the:
bar
chain
clutch shoe
cylinder co er
18
- English
ig 6
ig 7
ig 8
ig 9
in the
ig 10
A
B
C