Assembling The Ignition Module And Ywheel - Husqvarna 555 Workshop Manual

7.7 Assembling the ignition module and
flywheel
1
Run the cables through the opening in the crank-
case. Screw the earth cable in place. See gure 11.
it the cabling to the stop button.
2
Position the cable channel as outlined in gure 10.
N TE Take care that the cable channel is posi-
tioned correctly under the ignition module so that
the cables are not crushed.
3
Place the ignition module in position. See gure 13.
o not tighten the screws.
4
it the ywheel onto the crankshaft pin. Turn the
ywheel until the key ts into the key slot on the
shaft. See gure 12.
Tighten the screw for the ywheel.
5
nsert the plastic air gap tool, at a thickness of
0.3 - 0.1 mm, between the lugs on the ignition
module and ywheel. Turn the ywheel so that the
magnets are positioned opposite the ignition mod-
ule. Tighten the screws, at a tightening torque of
4.5- 6 Nm. Remo e the plastic air gap tool. it the
intake system as outlined in 7.14 Assembling the
intake system , the tank unit as outlined in 7.16
tank unit , and the air lter as outlined in Assem-
bling the carburettor .
6
Press the ignition lead into the holder on the parti-
tion wall.
7
Then t:
The air no le
The guide rail and press the cable in place
the spark plug hat by unscrewing the piston stop.
The starter, at a tightening torque of 2.5-3.5 Nm
The cylinder co er
ig 11
ig 12
ig 13
Repair nstructions
29
English -