MSI MS-6132 Instruction Manual page 58

CHAPTER 3

Boot From LAN First

During Enabled, the system will boot from the LAN card (if there's

any) first.

Boot Sequence

This category determines which drive the computer searches first for

the disk operating system (i.e., DOS). The settings are A,C,SCSI/C,A,SCSI/

C,CD-ROM,A/CD-ROM,C,A/D,A,SCSI/E,A,SCSI/F,A,SCSI/SCSI,A,C/

SCSI,C,A/C only. Default value is A,C,SCSI.

Swap Floppy Drive

Switches the floppy disk drives between being designated as A and

B. Default is Disabled.

Boot Up Floppy Seek

During POST, BIOS will determine if the floppy disk drive installed is

40 or 80 tracks. 360K type is 40 tracks while 720K, 1.2M, and 1.44M are all 80

tracks.

Enabled(default) BIOS searches for floppy disk drive to determine

Disabled

Boot Up NumLock Status

The default value is On.

On (default) Keypad is numeric keys.

Off

if it is 40 or 80 tracks. Take note that BIOS can

not tell from 720K, 1.2M , or 1.44M drive type as

they are all 80 tracks.

BIOS will not search for the type of floppy disk

drive by track number. There will be no warning

message if the drive installed is 360K.

Keypad is arrow keys.

3-10

AWARD

BIOS SETUP

AWARD

BIOS SETUP