MSI MS-6132 Instruction Manual page 103

CHAPTER 4

Display Activity/Device 6/Device 7/Device 8/Device 5/Device

0/Device 1/Device 2/Device 3/System Thermal

When set to Monitor, these options enable event monitoring on the

specified hardware interrupt request line. If set to Monitor and the computer

is in a power saving state, AMI

IRQ line. The computer enters the full on power state if any activity occurs.

AMI

BIOS reloads the Standby and Suspend timeout timers if

activity occurs on the specified IRQ line.

Power Button Function

During Suspend, if you push the switch once, the system goes into

suspend mode and if you push it more than 4 seconds, the system will be

turned off. During On/Off, the system will turn off once you push the

switch.

Ring Resume from Soft-Off

During Disabled, the system will ignore any incoming call from the

modem. During Enabled, the system will boot up if there's an incoming call

from the modem.

Note: If you have change the setting, you must let the system boot up until

it goes to the operating system. Then, power off the system. This

function will work the next time you power on.

RTC Alarm Resume From Soft-Off

This function is for setting the Date, Hour, Minute, and Second for

your computer to boot up. During Disabled, you cannot use this function.

During Enabled, Choose the Date, Hour, Minute, and Second:

RTC Alarm Date

RTC Alarm Hour

RTC Alarm Minute

RTC Alarm Second

Note: If you have change the setting, you must let the system boot up until

it goes to the operating system. Then, power off the system. This

function will work the next time you power on.

AMI

BIOS watches for activity on the specified

Choose which day the system will boot up.

Choose which hour the system will boot up.

Choose which minute the system will boot up.

Choose which second the system will boot up.

4-19

BIOS USER'S GUIDE