Removing And Installing Regulating Flap Control Unit J808; Removing And Installing Intake Manifold (Bottom Section) With Fuel Rail - Audi A8 2010 Workshop Manual

Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2.10 Removing and installing regulating flap
control unit -J808-
Removing
– Remove engine cover panel (rear)
– Unplug electrical connector -3-.
– Remove bolts -5- and -6-.
– Detach bypass elbow -1- with adapter (intermediate flange)
-2- and regulating flap control unit -J808- -4-.
Installing
Installation is carried out in the reverse order; note the following:
• Tightening torque
⇒ Fig. "„ Regulating flap control unit -J808- - tightening torque
and sequence"" , page 24
Note
Fit new O-rings.
– After renewing regulating flap control unit, perform
in
Adaption Guided Functions
2.11 Removing and installing intake manifold
(bottom section) with fuel rail
Special tools and workshop equipment required
♦ Tool inserts -V.A.G 1331/2-
♦ Hand vacuum pump -VAS 6213-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
Note
The removal and installation procedures are described for cylin‐
der bank 2 (left-side).
⇒ page 18 .
⇒ vehicle diagnostic tester .
Audi A8 2010 ➤
27
2. Injection system