Table of Contents
Advertisement
®
FlexCut
200 CE
OPERATION
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
UNLESS USING COLD FEED FEATURE,
WHEN FEEDING WITH GUN TRIGGER,
THE ELECTRODE AND DRIVE
MECHANISM ARE ALWAYS
ELECTRICALLY ENERGIZED AND
COULD REMAIN ENERGIZED SEVERAL SECONDS AFTER
THE WELDING CEASES.
FUMES AND GASES can be
dangerous.
•
Keep your head out of fumes.
•
Use ventilation or exhaust to
remove fumes from breathing zone.
WELDING, CUTTING and
GOUGING SPARKS can cause
•
•
Do not weld, cut or gouge on
containers that have held
combustibles.
ARC RAYS can burn.
•
Wear eye, ear and body protection.
PLASMA ARC can injure
•
Keep your body away from nozzle
and plasma arc.
•
Operate the pilot arc with caution.
The pilot arc is capable of burning
the operator, others or even
piercing safety clothing.
OBSERVE ADDITIONAL SAFETY GUIDELINES DETAILED
IN THE BEGINNING OF THIS MANUAL.
POWER-UP SEQUENCE
When power is applied to the FlexCut
initialize, during this time the system will purge plasma and shielding
gas while circulating coolant for 30 seconds. This is normal and
®
indicates FlexCut
200 CE is performing a self test, and mapping
(identifying) each component in the local ArcLink system. The UI and
status lights of the FlexStart
®
result of a system reset or configuration change during operation.
When the UI displays the cut settings and the status lights on the
FlexStart
and FlexCool™ become steady green the system is ready
®
for normal operation.
If the status lights do not become steady green consult the
troubleshooting section of this manual for further instruction.
GRAPHIC SYMBOLS THAT APPEAR ON
THIS MACHINE OR IN THIS MANUAL
WARNING OR
CAUTION
GAS PURGE
READ
INSTRUCTION
MANUAL
PROTECTIVE
GROUND
GAS INPUT
CUT
GRID or
EXPANDED
METAL
GOUGE
MARKING
POWER ON
POWER OFF
PLASMA GAS
SHIELD GAS
B-1
OPERATION
®
200 CE the User Interface will
and FlexCool™ will flash green as a
REMOTE
ETHERNET
ELECTRODE
GAS INPUT
WORK
Advertisement
Table of Contents
