Table of Contents
Advertisement
Operator Panel Assembly and Operator Panel Flexible Circuit (Model T40)
Step 1. If not already done, open the front cover (see "Covers" on page 138).
Step 2. Remove the front bezel assembly (see "Front Bezel Assembly (Model T40)" on
Step 3. Refer to Figure 102.
Figure 102. Removing the Operator Panel Flexible Circuit and the Operator Panel from
a Model T40
Step 4. Unscrew the screw 4 .
Step 5. Unplug the flexible circuit 1 from the operator panel.
Step 6. Unscrew the screws 3 and 5 .
Step 7. Remove the operator panel assembly 2 .
Step 8. Replace parts in the reverse sequence.
188
7133 Models D40 and T40 Service Guide
page 183).
1
Note: Ensure that the latches of the operator panel flexible circuit and the disk
drive status lights flexible circuit engage fully in the slots of the 7133
frame assembly.
2
3
4
5
Advertisement
Table of Contents
