Table of Contents
Advertisement
ESD Cover (Model D40)
Note: Unless you have a particular reason to do so, do not switch off the using system
Step 1. If not already done, open the front cover (see "Covers" on page 138).
Step 2. Refer to Figure 94.
Figure 94. Removing the ESD Cover from a Model D40
Step 3. Slide the electrostatic discharge (ESD) cover 3 forward until it disengages
Step 4. Carefully lift the ESD cover upward. Note that the operator panel flexible
Step 5. Carefully disengage the two flexible circuits from the slots in the ESD cover.
Step 6. Remove the ESD cover.
Step 7. Replace parts in the reverse sequence.
176
7133 Models D40 and T40 Service Guide
or the 7133 when removing or installing the operator panel assembly.
1
2
3
from the operator panel assembly.
2 and the disk drive status light flexible circuit 1 are engaged in the
circuit
slots of the ESD cover.
Advertisement
Table of Contents
