Power Switch and Cable Assembly (Model T40)
Attention:
a cable assembly. If you are exchanging the FRU, ensure that you exchange both parts
of the FRU.
Step 1. If not already done, open the front cover (see "Covers" on page 138).
Step 2. Remove the front bezel assembly (see "Front Bezel Assembly (Model T40)" on
Step 3. If the bezel assembly that you have just removed is an early type (see "Front
190
7133 Models D40 and T40 Service Guide
The power switch and cable assembly FRU consists of a power switch and
page 183).
Bezel Assembly (Model T40)" on page 183), go to "Early-Type Power Switch
and Cable Assembly" on page 191.
If the bezel assembly that you have just removed is a later type, go to
"Later-Type Power Switch and Cable Assembly" on page 193.