Keyboard Element Cover; Keyboard Element Keyboard Assembly - IBM 3101 Maintenance Information

1. Remove the Keyboard Element cover, as described under "Keyboard
Element Cover."
, 2. Remove two screws, one at each end
Q)
of the switch assembly (see
Figure 4-4).
3. Lift the switch
protrude into
underside.
assembly from the Keyboard assembly pins, which
the switch-assembly connectors
©
from the
4. When reinstalling, ensure that the pins on the Keyboard assembly
properly align with the connectors on the switch assembly; the
switch assembly easily fits into place when the pins are aligned.
0
0
• g g g g g
y
9
g • g g g g g 9 g 9
I+
g 9 g g g g 9 9
I
+
g 9 g 9 g g 9
a
CID
A---------~----------------~~~.
~------------------------~~~
Figure 4-4. Setup Switch Assembly~""·~
1. Remove the Keyboard Element cover, as described under "Keyboard
Element Cover," and the Keyboard assembly, as described under
"Keyboard Element Keyboard Assembly."
2. Push the clicker-assembly bail fastener (shown in Figure 4-5),
toward the rear of the Keyboard Element, then raise the fastener
over the cast tab as you let it move forward slowly.
4-8