Connecting To Push Buttons - DigiTech digiGate User Manual

Step 4: Connect a switch cable to the NO (Normally Open) terminal on the garage control
unit with the other end into digiGate terminal 1.
Step 5: Connect a second switch cable to the COM (earth/ground/negative) terminal on the
garage control unit with the other end into digiGate terminal 2.
Step 6: Repeat the process with the second garage control unit connecting to terminals 6 &
7 on digiGate.
Step 7: With the cables connected, position the digiGate onto the mount you have fixed on
the wall. Instructions can be found in section 10.
Step 8: Connect power, WiFi antenna (if used) and switch on. Power types and instructions
can be found in section 5.4.

9.1.2 CONNECTING TO PUSH BUTTONS

Note: This section is for connecting to your garage push button switches. If you do not have/do not want to
connect to the push button switches, please refer to the instructions above on how to connect direct to the
garage control units themselves.
The following steps outline connecting digiGate to a push button switch for door number 1.
Connecting to door 2 is the same except with terminals 6 & 7 on digiGate instead of 1 & 2.
Step 1: Safely remove the front of the push button switch. There should be some accessible
screws on the outside which need to be removed. Once removed, carefully lift off the front
panel but be careful not to force the panel off in case there are some cables attached, in
which case remove these gently.
Step 2: Locate the two terminals connected to the reverse of the garage button.
Step 3: Connect a cable from digiGate terminal 1 to one of the terminals on the switch.
Step 4: Connect a cable from digiGate terminal 2 to the other terminal on the switch.
Instructions continue on the next page
digiGate.co.uk
23