Connecting To Push Button - DigiTech digiGate User Manual

Step 4: Connect a switch cable to the NO (Normally Open) terminal on the garage control
unit with the other end into digiGate terminal 1.
Step 5: Connect a second switch cable to the COM (earth/ground/negative) terminal on the
garage control unit with the other end into digiGate terminal 2.
Step 6: With the cables connected, position the digiGate onto the mount you have fixed on
the wall. Instructions can be found in section 10.
Step 7: Connect power, WiFi antenna (if used) and switch on. Power types and instructions
can be found in section 5.4.

7.1.2 CONNECTING TO PUSH BUTTON

Note: This section is for connecting to your garage push button switch. If you do not have/do not want to
connect to a push button switch, please refer to the instructions above on how to connect direct to the garage
control unit itself.
Step 1: Safely remove the front of the push button switch. There should be some accessible
screws on the outside which need to be removed. Once removed, carefully lift off the front
panel but be careful not to force the panel off in case there are some cables attached, in
which case remove these gently.
Step 2: Locate the two terminals connected to the reverse of the garage button. Connect
cable 1 and 2 from the digiGate to these as shown in the diagram below. It does not matter
which cable connects to which terminal as long as they are not both connected to the same.
Step 3: Re-assemble the override switch again with the front fixed back in place. Ensure no
metal from the cables is exposed.
Instructions continue on the next page
digiGate.co.uk
18