Poe Splitter; Electric Gate Installation; Automatic Closing Pre-Requisite - DigiTech digiGate User Manual

5.4.3 POE SPLITTER

Note: The POE splitter is not waterproof and should be kept inside an IP rated waterproof enclosure.
Step 1: Ethernet Male End
Connect the Ethernet cable from the POE splitter
into the digiGate Ethernet port.
Step 2: Micro USB Power
Connect the micro-USB power connector into the
digiGate power port.
Step 3: Ethernet
Connect the POE injected Ethernet cable into the
female Ethernet port on the POE splitter. The POE
splitter will light up and digiGate will boot up.

6 ELECTRIC GATE INSTALLATION

Note: It is recommended that digiGate is installed by a qualified electrician to avoid any incorrect wiring,
potentially resulting in malfunction and/or injury. Damaged products due to incorrect installation without
following this guide will result in a void warranty.

6.1 AUTOMATIC CLOSING PRE-REQUISITE

If you are using the latch/timer function on your digiGate system, your gate controller must
have auto-close enabled. Auto close is where your gate closes by itself automatically after a
default 'pause time'. We recommend having a 15 second pause time which is enough time
for a vehicle to enter where the gate will then close itself after.
Gate systems that are programmed to operate via a separate open and close button are not
supported with timer/latch commands. This is because digiGate gate systems have 1 output
which solely instructs the gate to open as normal or latch open.
digiGate.co.uk
14