5.4 CONNECTING POWER
This section explains how to connect your digiGate to power via the supply type chosen
when your system was ordered.
5.4.1 5V MAINS PLUG (110/230V)
Installing in a waterproof enclosure
Step 1:
Ensure all power is switched off.
Step 2:
Plug your mains plug power supply into a waterproof socket or socket installed
inside the waterproof enclosure.
Step 3:
Insert the micro-USB connector in the
digiGate unit.
Step 4:
Switch on the power to the socket. Your
digiGate will boot up.
Installing inside a building
Step 1:
Ensure all power is switched off.
Step 2:
Plug your mains plug power supply into a nearby socket.
Step 3:
Insert the micro-USB connector in the digiGate unit.
Step 4:
Switch on the power to the socket. Your digiGate will boot up.
5.4.2 HARDWIRE KIT (110-240V)
Note: The digiGate hardwire kit is not waterproof and should be installed in an IP rated waterproof enclosure.
Step 1: Unscrew socket lid
Using a screwdriver, unscrew the back lid from the
socket to reveal the screw terminal points inside for
Live, Neutral and Earth.
Instructions continue on the next page
digiGate.co.uk
12