Ryobi R36LMW16 Manual page 17

6. Install the new blade, washer, spacer,
and nut.
7. Insert blade change u-bolt into the cutting
deck holes to prevent the blade from
spinning during tightening the blade nut.
Hand-tighten the nut until the blade is
secured and does not shake.Then use a
spanner to further tighten the nut by 1/2
turn (35-40 Nm torque).
WARNING: Ensure to remove blade change
lock and place back into compartment before
re-installing batteries to begin mowing again.
EMPTYING THE GRASS CATCHER
NOTE: Stop mowing when the grass catcher
is full. Empty the grass catcher before
resuming operation.
1. Release the on/off lever to turn off the
product.
6
7
2
1
A
1
Blade bolt tightening
torque (35~40 Nm)
B
Maintenance
17