7.2.2
Changing a parameter without changing the network
configuration
To change only the created module parameter of the slave station without changing the network configuration, set the
parameter in the following procedure.
1.
Display the CC IE Field Configuration window.
• When the master/local module is the QJ71GF11-T2
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET] [CC IE
Field Configuration Setting] button
• When the master/local module is the LJ71GF11-T2
Project window [Parameter] [Network Parameter] [Ethernet/CC IE Field] [CC IE Field
Configuration Setting] button
2.
Set the module parameter by referring to the following.
Page 110, Section 7.1 (2)
CHAPTER 7 VARIOUS SETTINGS
123
7