Chapter 7 Various Settings; Parameter Settings - Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual

CHAPTER 7
This chapter describes the setting procedures of a temperature control module.
7.1

Parameter Settings

Set the parameter of this module with the network parameter written to the CPU module of the master station. For the
setting procedure of the master station, refer to the following.
 User's manual for the master/local module used
Remark
● Check in advance the box next to "Set network configuration setting in CC IE Field configuration window" in
MELSECNET/CC IE/Ethernet Module Configuration window.
● Set the same number of points of the temperature control module to remote I/O signals and remote register. If the set
points are less than the ones of the temperature control module, the cyclic transmission is performed only for the set
points of data from the start, the temperature control module may not operate normally. In that case, an error does not
occur.
108
VARIOUS SETTINGS