Advertisement
When the alarm is sounding, pressing the "SNOOZE" will turn it off for the time that
C.
was selected in the programming mode (section II.A.2.c.). The snooze is activated by
pressing back on the entire unit while the cover is open. The actual button is on the
bottom of the unit and is pressed by the cover when pushed back. If the setting is "0",
the alarm will turn off for 24 hours. During the snooze period, the lower screen will
show a countdown until the alarm will sound again. If the snooze bar is pressed again
during the original snooze period, the period will be reset. Once the period is finished,
the alarm will sound again. Pressing any key other than the snooze key will turn off the
alarm for 24 hours.
OPERATING SCREENS
IV.
The exact time will always be displayed in the upper portion of the screen, and the US
A.
map will show when the time zone is set to the continental US (with the time zone
selected showing in black). The lower portion of the screen has five different screens
that can be selected. The default is "DAY, MONTH, DATE" as shown below.
Press the "MODE" key to select which screen to show. It will change in order as
B.
follows:
DAY MONTH DATE
1.
MONTH DATE YEAR
2.
SECONDS
3.
ALARM 1 TIME
4.
ALARM 2 TIME
5.
While in non-alarm mode, pressing the "SNOOZE" bar will show the "ALARM1"
C.
and "ALARM2" briefly in the lower section.
TRAVELING
V.
When traveling, it will only be necessary to change to the appropriate time zone.
A.
Please note that the clock will only search for a signal when it is set between "GMT-4
and GMT-10.The alarm clock will set to any time zone from "GMT" to "GMT-12".
Outside this range, it will only be necessary to set the hour to the correct hour, leaving
the time zone set to your local time zone. For example, if you are traveling to Hong
Kong, you will need to manually set the hour to the local time. When the clock is back
in the US, it will search for a signal and set to the proper time according to the time
zone selected.
5
Advertisement
