Advertisement
"Sno" will show at the bottom of the screen, and a number will flash at the top. This
c)
is the setting for the length of the alarm snooze. Press the "+" key to advance the
length from 0 (no snooze)) to 59 minutes. This sets the time the alarm is silenced after
pressing the SNOOZE key while the alarm is sounding. Press the SET key.
The hour will now flash. Press the "+" key to advance to the correct hour; be sure to
d)
note the correct am/pm setting ("PM" will show for pm setting, nothing for the am
setting). Press the SET key.
The minutes will now flash. Press the "+" key to advance the minutes. By holding
e)
the "+" key, the minutes will advance in five minute increments. Press the SET key.
The year will now flash. Press the "+" key to advance to the correct year. Press the
f)
SET key.
The month will now flash. Press the "+" key to advance to the correct month. Press
g)
the SET key.
The date will now flash. Press the "+" key to advance to the correct day. Press the
h)
SET key.
The day of the week will now flash (Sun, Mon, etc.). Press the "+" key to advance to
i)
the correct day of the week. Press the SET key.
"12" or "24" will now flash. Press the "+" key to select either 12 –hour or 24-hour
j)
(military time). The programming is now complete.
PROGRAMMING SEQUENCE
2.
→Time Zone→DST On/OFF→Snooze
Setting→Hour→Minute→Year→Month→Date→Day→12/24 hour format
SETTING THE ALARMS
III.
La Crosse Technology's travel alarm clock has two separate alarms that can be set.
Each alarm has a distinctive sound and operate independently.
Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting
A.
mode. The alarm time will flash. Press the "HOUR" key to advance the hour of the
alarm, and press the "MIN" key to advance the minutes of the alarm. If no button is
pressed within fifteen seconds, the alarm will set and will activate, and the clock will
revert to the normal operating screen. The picture below shows both alarms activated.
To activate/deactivate the alarm, press the "ALM1" or "ALM2" key once, depending
B.
on which alarm needs to be activated.
"Alarm 1"
activated
"Alarm 2"
activated
4
Advertisement
