Page 2
Topic Inventory of Contents About WWVB Program Mode Initial Set-up Time Zone and DST Setting Display Mode Setting Setting the Alarm Operating the Alarm Manual Time Setting Option Troubleshooting Maintenance and Care Specifications Warranty Information Page...
More information on the atomic clock and WWVB can be found at www.nist.gov PROGRAM MODE Following is a list of steps to set up your new La Crosse Technology travel alarm clock. • Please begin by removing the battery cover on the rear of the travel alarm shown in figure one.
Time Zone and DST (Daylight Saving Time) Setting You can manually set the time zone and the DST option on your travel alarm by pressing and holding the “MODE/MIN” button (figure two) on the front of your travel alarm for 4 seconds.
20 seconds and the travel alarm will automatically return to the normal display mode. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www.lacrossetechnology.com Problem: The time and date will not set initially.
Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the travel alarm in for repairs, please contact La Crosse Technology. The travel alarm will be repaired or replaced with the same or similar a similar model.
Page 7
For warranty work, technical support, or information, contact La Crosse Technology at: support@lacrossetechnology.com sales@lacrossetechnology.com (information on other products) www.lacrossetechnology.com THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2.