Time Zone; Setting Alarms; Snooze Setting; Operating Screens - La Crosse Technology WT-2160 Instruction Manual

PROGRAMMING SEQUENCE
2.
→Time Zone→DST On/OFF→Snooze
Setting→Hour→Minute→Year→Month→Date→Day→12/24 hour format
SETTING THE ALARMS
III.
La Crosse Technology's travel alarm clock has two separate alarms that can be set.
Each alarm has a distinctive sound and operate independently.
Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting
A.
mode. The alarm time will flash. Press the "HOUR" key to advance the hour of the
alarm, and press the "MIN" key to advance the minutes of the alarm. If no button is
pressed within fifteen seconds, the alarm will set and will activate, and the clock will
revert to the normal operating screen. The picture below shows both alarms activated.
To activate/deactivate the alarm, press the "ALM1" or "ALM2" key once, depending
B.
on which alarm needs to be activated.
When the alarm is sounding, pressing the "SNOOZE" bar will turn it off for the time
C.
that was selected in the programming mode (section II.A.2.c.). If the setting is "0", the
alarm will turn off for 24 hours. During the snooze period, the lower screen will show a
countdown until the alarm will sound again. If the snooze bar is pressed again during
the original snooze period, the period will be reset. Once the period is finished, the
alarm will sound again. Pressing any key other than the snooze key will turn off the
alarm for 24 hours.

OPERATING SCREENS

IV.
The exact time will always be displayed in the upper portion of the screen, and the US
A.
map will show when the time zone is set to the continental US (with the time zone
selected showing in black). The lower portion of the screen has five different screens
that can be selected. The default is "DAY, MONTH, DATE" as shown below.
Press the "MODE" key to select which screen to show. It will change in order as
B.
follows:
"Alarm 1"
activated
"Alarm 2"
activated
5