Table of Contents
Advertisement
OUTDOOR TEMPERATURE TRANSMITTER:
TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please follow the
steps below:
1.
Remove the cover.
2.
Insert the batteries, observing the correct polarity (see marking inside battery compartment).
3.
Replace the battery cover on the unit.
Alkaline batteries are recommended for use in both units. Avoid using rechargable
batteries.
TO INSTALL AND REPLACE BATTERIES IN THE ATOMIC CLOCK
The atomic clock uses 3 x AA, 1.5V batteries. To install and replace the batteries, please follow
the steps below:
1.
Pull down on the tab at the top of the battery cover and lift up to remove the cover.
2.
Insert batteries observing the correct polarity (see marking inside battery compartment).
3.
Replace compartment cover.
DO NOT SET THE CLOCK.
SETTING UP:
Alkaline batteries are recommended for use in both units. Avoid using
rechargable batteries.
NOTE: Do not set the clock until the outdoor temperature is displayed.
1.
Place batteries in the outdoor transmitter first, then into the atomic clock. DO NOT
PRESS ANY BUTTONS FOR 15 MINUTES.
•
•
Mounting Bracket
2
Remote transmission of outdoor
temperature to the atomic clock by 433
MHz signals
Wall mounting case
Hide quick links:
Advertisement
Table of Contents
