Troubleshooting - La Crosse Technology WS-8248U-CH Instruction Manual

Atomic clock with indoor temp/humidity and outdoor temperature
Table of Contents

Advertisement

3) Remove the protective strip from the other side of the tape. Position the outdoor temperature
transmitter in the desired location, ensuring that the atomic clock can receive the signal.

TROUBLESHOOTING

Problem:
The LCD is faint.
Solution:
1) Replace the batteries.
No reception of WWVB signal
Problem:
Solution:
1) It may help reception to face the front of the atomic clock in the general
direction of Ft. Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the atomic clock is at least 6 feet (2 meters) from any electrical
devices, i.e. TV sets, computers, or other radio controlled clocks.
4) Remove batteries for five minutes, reinsert and leave the unit alone
overnight without pressing any keys.
Problem:
Hour is incorrect (minute and date are correct).
1)
Be sure the correct time zone and daylight saving time are selected.
Solution:
Problem:
"OFL" appears in the indoor temperature section of the LCD
Solution:
1) Move the atomic clock to an area with warmer or cooler surrounding
temperature. Current surrounding temperatures are outside measuring
range.
"--.-" appears in the outdoor temperature section of the LCD.
Problem:
Solution:
1) Remove the batteries of both units for one minute, then reinsert them
again. Make sure the batteries are new and fresh.
2) Move the atomic clock closer to the transmitter or place the transmitter
closer to the atomic clock. Make sure the clock is at a receivable range
from the transmitter.
3) Move the units to another location. Interferences from other electrical
devices operating on the same signal frequency (433MHz) may prevent
correct signal transmission and reception.
Problem:
"OFL" appears in the outdoor temperature section of the LCD.
1) Wait until the current surrounding temperature cools down or increases.
Solution:
Current temperature is outside of the measuring range of the transmitter.
The outdoor temperature will be displayed again once the current
surrounding temperature is within the range of the transmitter.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ws-8248u-oakWs-8248Ws-8248u

Table of Contents