Detailed Set Up Guide; Battery Installation - La Crosse Technology WS-8015TWC Instruction Manual

DETAILED SET-UP GUIDE
I.

Battery Installation

Batteries will fit tightly. To avoid start-up problems, make sure that the
batteries do not spring free. Also be sure to insert alkaline batteries into the
remote thermo/hygro sensor first, then the indoor weather station. Initial set
up should be done with the remote thermo/hygro sensor and indoor weather
station in the same room. The units should be permanently mounted only
after the signal reception has been verified.
Rain
Cover
A. Remote Temperature and Humidity Sensor, TX4U
1. Pull the cylindrical rain cover off the transmitter.
2. Remove the battery cover (located on the backside of the
transmitter, above the mounting post and bracket). Press the arrow
and slide the battery cover off.
3. Observing the correct polarity install 2 Alkaline AA batteries.
4. Replace battery cover, and place rain cover snugly onto the
transmitter.
B. Weather Center
1. Remove the battery cover (the cover
has white writing on it).
2. Observe the correct polarity, and
install three Alkaline AA batteries.
3. Do not press any buttons for at least
ten minutes. If a button is pressed
before the Weather Center has
received information from the
TX4U sensor, no data will be
received from that sensor until reset.
4. Replace the battery cover.
Mounting
Bracket/Recept
Thermo-Hygro
Transmitter
5
Battery
Cover