Detailed Set Up Guide; Battery Installation - La Crosse Technology WS-9115 Instruction Manual

DETAILED SET-UP GUIDE
I.

Battery Installation

Batteries will fit tightly. To avoid start-up problems, make sure that the
batteries do not spring free. Also be sure to insert alkaline batteries into the
remote thermo/hygro sensor first, then the indoor weather station. Initial set
up should be done with the remote thermo/hygro sensor and indoor weather
station in the same room. The units should be permanently mounted only
after the signal reception has been verified.
Rain
Cover
A. Remote Temperature and Humidity Sensor
1. Pull the cylindrical rain cover off the sensor.
2. Remove the battery cover (located on the backside of the sensor,
above the mounting post and bracket). Press the arrow and slide
the battery cover off.
3. Observing the correct polarity install 2 Alkaline AA batteries.
4. Replace battery cover, and place rain cover snugly onto the sensor.
B. Indoor Weather Station
1. Remove the battery cover (the
cover has white writing on it).
2. Observe the correct polarity,
and install three Alkaline AA
batteries.
3. Do not press any buttons for
at least ten minutes. If a
button is pressed before the
indoor weather station has
received information from the
TX4U sensor, no data will be
received from that sensor
until reset.
4. Replace the battery cover.
Mounting
Bracket/Recept
Thermo-Hygro
Sensor
5
Battery
Cover