Advertisement
Attach the MR28 to the Mount Cradle
(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount
where you have already installed the mount cradle.)
The MR28 attaches to the mount cradle with two tabs on the cradle that insert into the MR28, and is secured to the
cradle using one screw.
To attach the MR28 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.
Since the cradle is already mounted to the wall, guide the MR28 towards the top tab and insert the top tab into the
MR28's slot.
Then adjust the MR28 to guide the MR28's bottom slot into the cradle's bottom tab until it clicks into place. Once in
place, the MR28 should be secured to the cradle by using one of the included screws in the cradle's bottom tab.
8
Advertisement
