Section 2. Unit Design - Trane GAF2A0A36S31EE Installer's Manual

Section 2. Unit Design

2.1 Cabinet Penetration
Important: Due to the unique design of this unit,
which allows the electrical wiring to be routed within
the insulation, do not screw, cut, or otherwise punc-
ture the unit cabinet in any location other than the
ones illustrated.
Important: Under no conditions should metal strap-
ping be attached to the unit to be used as support
mechanisms for carrying or suspension purposes.
2.2 Panel Removal
The unit contains four (4) access panels: Blower,
Coil, Line Set, and Heater.
The Blower, Coil, Line Set, and Heater panels are
removed using a Phillips head screwdriver.
NOTE: The Blower, Coil and Heater panels must be
removed prior to removing the Line Set panel.
NOTE: The Coil Panel should be removed before
the other panels.
Screws are allowed up to 3- 3/4"
from the top of the cabinet
(heater compartment).
(Typical both sides)
#3 Size Phillips
3