Table of Contents
Advertisement
AUTOMATIC VOLUME
CONTROL
This function adjusts the volume level to
compensate for engine and road speed
noise.
1.
Press the MENU button repeatedly
until AVC is shown in the display.
2. Use the seek up or seek down button
to adjust the setting.
3. Press the MENU button or allow the
system to time out to confirm your
selection.
AUDIO DISTORTION
REDUCTION (CLIP)
This function automatically detects sound
distortion and reduces the volume level
until the distortion has been eliminated.
This means that whilst the display might
change numerically when you raise the
volume manually with the control, there
may be no actual increase in sound.
1.
Press and hold the MENU button until
the display changes.
2. Press the MENU button repeatedly
until CLIP is shown in the display.
3. Using the seek up or seek down button
turn the function on or off.
4. Press the MENU button or allow the
system to time out to confirm your
selection.
ALTERNATIVE FREQUENCIES
Many programmes broadcast on the FM
waveband have a PI (programme
identification) code, which can be
recognised by audio units.
TourneoConnect/TransitConnect (TC7) Vehicles Built From: 24-05-2011, Vehicles Built Up To: 31-12-2013
Audio unit menus
If your radio has AF (alternative
frequencies) tuning switched on and you
move from one transmission area to
another, this function will search for and
switch to a stronger station signal, if one
can be found.
Under certain conditions, however, AF
tuning may temporarily disrupt normal
reception.
When selected, the unit continually
evaluates signal strength and, if a better
signal becomes available, the unit will
switch to that alternative. It mutes while
it checks a list of alternative frequencies
and, if necessary, it will search once across
the selected waveband for a genuine
alternative frequency.
It will restore radio reception when it finds
one or, if one is not found, the unit will
return to the original stored frequency. On
certain units, NOT FOUND will be shown
in the display.
With AF-MAN selected, the unit operates
in a similar way to AF-AUTO or AF-ON, but
only searches for an alternative frequency
when prompted by pressing a preset
button.
With AF-OFF selected, the original stored
frequency remains selected. In this mode,
AF-OFF will be displayed every time the
unit is turned on.
1.
2. Press the MENU button repeatedly
3. Using the seek up or seek down button
4. Press the MENU button or allow the
140
Press and hold the MENU button until
the display changes.
until AF is shown in the display.
select the required setting.
system to time out to confirm your
selection.
Advertisement
Table of Contents
