Station Tuning Control - Ford TOURNEO CONNECT 2013 Owner's Manual

If a non-traffic station is selected or
recalled using a preset button, the audio
unit will remain on that station unless TA
is turned off, then on again.
Note: If TA is on and you select a preset or
manual tune to a non TA station no traffic
announcement will be heard.
Local or distant traffic
The number of RDS or EON traffic
announcements may become excessive
in some areas so there is an option to
select between local traffic information
and all available information.
1. Press and hold the MENU button until
the display changes.
2. Press the MENU button repeatedly
until TA is shown in the display.
3. Press the seek up or seek down button
to select either local (TA LOCAL) or
distant (TA DIST) traffic
announcements.
4. Press the MENU button or allow the
menu to time out to confirm your
selection.
Note: Either TA-L or TA-D will be shown in
the display.
Traffic announcement volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume
1. Press and hold the TA button.
2. Rotate the volume control to make the
necessary adjustment.
Note: The selected level will be shown in
the display.
TourneoConnect/TransitConnect (TC7) Vehicles Built From: 24-05-2011, Vehicles Built Up To: 31-12-2013
Audio unit operation
Ending traffic announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA during the
announcement.
Note: If you press TA at any other time it
will switch all announcements off.

STATION TUNING CONTROL

Seek tuning
Select a waveband and briefly press the
seek up or seek down button. The unit will
stop at the first station it finds in the
direction you have chosen.
Manual tuning
1.
2. Press the seek up or seek down button
Scan tuning
The scan function allows you to listen to
10 seconds of each station detected.
1.
2. Press the seek up or seek down button
3. Press the seek up or seek down button
139
Select a waveband and press the
MENU button until MAN is shown in
the display.
to tune up or down the waveband in
small increments or press and hold to
increment quickly, until you find a
station you want to listen to.
Press the MENU button repeatedly
until SCAN is shown in the display.
to scan up or down the selected
waveband.
or the MENU button to continue
listening to a station.