Siemens SiPass integrated Reference Manual page 38

Host event tasks
7
Targets / Commands
38 | 66
Target Command
Floor Point As for Floor Points
Group
Input Point Disable
Enable
Pulse
Set state to Alarm
Set state to Normal
Input Point Same as Input Points See above
Group
Intrusion Area Arm Intrusion Area
Point
Disarm Intrusion Area Disarms the selected intrusion area.
Isolate Input
Part Arm Intrusion
Area
Part Arm B Intrusion
Area
Intrusion Area Same as Intrusion
Point Group Area Points
Message
Forward to Pager(s)
Forwarding
Send to all OPC
Clients
Forward to Email(s)
Output Point Allow Access
Lock
Unlock
Toggle
Description
See above.
Disables the input, if it is currently enabled, until
the next change in Time Schedule.
Enables the input, if it is currently disabled, until
the next change in Time Schedule.
Sends a pulse command to the selected Input.
This is only applicable for Sintony input points of
type "Serial Coms Input"
Set the input to state Alarm.
Set the input to state Normal
Arms the selected intrusion area.
Manually isolates a point from an intrusion area,
excluding that point from a seal check when the
area is armed.
Arms inputs which are marked as Part Arm.
Arms inputs which are marked as Part Arm
B.(SPC only)
See above
Allows a message to be forwarded to one or
more pagers if the host event task has been
triggered.
Sends details of the trigger to all OPC
connections defined in the
Allows a message to be forwarded to one or
more email addresses if the host event task has
been triggered.
Allows access at an output point. (Operates in
the same way as if a cardholder used their card
to gain valid access at the same point). The
output point will only be activated (unlocked) for
the pre-set latch time.
Locks the output temporarily (if the output is
currently unlocked) until the next change in Time
Schedule.
Enter the Time into the Data field, using the
format HH:MM:SS.
Unlocks the output temporarily (if the output is
cur-rently locked) until the next change in Time
Schedule.
Enter the time into the Data field, using the
format HH:MM:SS.
The state of the output will be toggled to the
reverse state.
Components
dialog.
A6V11144326