Manual Override - Siemens SiPass integrated Reference Manual

Manual Override

6
6 Manual Override
24 | 66
Manual Commands can be used to manually control specific points, areas,
elevators and units at your site. The following table lists the commands that can be
used to control each type and a brief description of the action that will be
performed.
Type Command
Access Allow Access
Block Door
Cancel Permanent
Action
Intrusion Control -
Disable
Intrusion Control –
Enable
Intrusion Control –
Restore Config
Lock Door
Reader Buzzer Off
Reader Buzzer On
Reset Reader
Tamper
Restore Access
Mode
Restore additional
access mode
Restore Dual
Custody Config Mode
Return to Time
Schedule Control
Set "Daily Code"
additional access
mode
Set "No Additional
Access"
Set "PIN as Card"
additional access
mode
Description
The door will unlock, remain unlocked for the
defined period of time and then relock, as per a
normal valid card badge.
The door will remain blocked, unable to be opened.
Any current Permanent Command or Event Task,
or Access/Internal Action operating on the point will
be cancelled. The next Control State in the Control
State Queue will take effect.
Disable Intrusion Control on the selected access
point.
Enable Intrusion Control on the selected access
point.
Restore Intrusion Control to whatever is configured.
The door latch will be locked until the next unlock
command is received.
The Duration can be set to:
Until time schedule change
●
Permanents
●
The Reader buzzer is turned off. Only applies to the
Siemens reader range.
Reader buzzer is turned on. Only applies to the
Siemens reader range.
Resets the reader tamper input. Only applies to the
Siemens reader range.
Returns the access point to the normal access
operation mode defined in the Components screen.
Returns the access point to the normal additional
access operation mode defined in the Components
screen.
Restores the Dual Custody mode to what is
configured.
The door latch will return to normal Time Schedule
control.
Set the additional access for the selected access
point to Daily Code.
Set the additional access for the selected access
point to No Additional Access.
Set the additional access for the selected access
point to PIN as Card.
A6V11144326