Targets / Commands - Siemens SiPass integrated Reference Manual

7.2 Targets / Commands

A6V11144326
Target Command
ACC Trigger Set Trigger
Clear Trigger
Access Point Allow Access
Lock Door
Unlock Door
Set Mode "Card Only" Enables Card Only operation at an access point.
Set Mode "Card and
PIN"
Set Mode "H. V. Card
Only"
Set Mode "H. V. Card
and PIN"
Set Mode "V. O. Card
Only"
Set Mode "V. O. Card
and PIN"
Set Mode "D. R. Card
Only"
Set Mode "D. R. Card
and PIN"
Set Mode "Disabled"
Restore Access Mode Restores the previous access mode at an access
Reset Reader Tamper Resets the reader tamper. Only applies to the
Block Door
Host event tasks
Targets / Commands
Description
An ACC Trigger allows you to trigger a Controller
event task from a software event, like a Host
event task.
This Command activates the trigger selected.
Any Controller Event tasks of type "Host Control"
will be listed in the Location drop-down menu.
This Command clears the trigger selected, if it is
currently activated.
Allow access as if a valid card has been
presented at the reader. The door lock will re-
lock after the defined Latch time.
Locks the door temporarily until the next change
in Time Schedule.
Unlocks the door temporarily until the next
change in Time Schedule.
Refer to Operational modes page 22 for more
information.
Enables Card and PIN operation at an access
point. Refer to Operational modes page 22 for
more information.
Enables Host Verification Card Only operation at
an access point. Refer to Operational modes
page 22 for more information.
Enables Host Verification Card and PIN
operation at an access point. Refer to
Operational modes page 22 for more
information.
Enables View Only Card Only operation at an
access point. Refer to Operational modes page
22 for more information.
Enables View Only Card and PIN operation at an
access point. Refer to Operational modes page
22 for more information.
Enables Delayed Reporting Card Only operation
at an access point. Refer to Operational modes
page 22 for more information.
Enables Delayed Reporting Card and PIN
operation at an access point. Refer to
Operational modes page 22 for more
information.
Disables an access point. Refer to Operational
modes page 22 for more information.
point. Refer to Operational modes page 22 for
more information.
Siemens reader range.
Blocks the door and prevents cards from being
used to gain access at the door using the
selected reader.
7
35 | 66