Smeg SO610S3PS Manual page 36

1. After entering the special functions menu,
press the button until the
function is selected.
2. Press the button to confirm.
3. Fill the reservoir with clean water until the
maximum level indicator light
displays.
4. At the end, remove the funnel and place the
loading drawer back in its place.
5. Press the button to start the function.
The duration and temperature
parameters cannot be changed by the
user.
At the end,
and a beep is activated.
90 - CLEANING AND MAINTENANCE
is displayed and flashes
6. Turn the function knob to position 0 to exit
the function.
Programmed Vapor Clean cycle
It is possible to program the Vapor Clean
function start time, like any cooking function.
7. After selecting the Vapor Clean function,
press the button.
The and indicator lights on the display
flashes.
8. Turn the temperature knob to set the function
end time.
9. Press the button to confirm.
The appliance waits until the set start time to start
the Vapour Clean function.
Reservoir draining
Before draining the reservoir, wait for
the oven to cool down, leaving the
door open. To make sure that the water
remaining in the reservoir is not too hot,
wait at least 40 minutes.
After Vapor Clean function:
1. Open the door
2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. From position 0, turn the function knob to the
left by one position. The
The appliance suggests the Drain reservoir
function
.
4. Press the button to confirm the function.
button flashes.
91477A665/A