Smeg SO610S3PS Manual page 31

Water hardness
This mode allows you to set the water
hardness value in order to optimise the
descaling process.
The appliance is factory set for water of
medium hardness (3).
1. After entering the settings menu, turn the
temperature knob until the Water hardness
function is selected.
2. Turn the temperature knob to set the water
hardness (values from 1 to 5) (e.g. "1").
3. Press the button to go to the next
setting or press the
If your mains water supply is too hard,
we recommend using a water softener.
Request information on the hardness of
your water from your local water board.
Depending on the degree of water hardness
(°dH or °dF), the number of hours after which
91477A665/A
button to confirm.
descaling is required is as follows:
Value °dH
1 0 - 8
2 8 - 14
3 14 - 21
4 21 - 38
5 31 - 50
Keep warm
This mode allows the appliance
after cooking finishes with a cooking
cycle for which a duration has been set
(if this is not manually interrupted), to
keep cooked food warm (at low
temperatures) without altering the taste
and aromas obtained during cooking.
1. After entering the setting menu, press the
button until the keep warm function is
selected.
2. Turn the temperature knob to activate the
keep warm function.
3. Press the button to go to the next
setting or press the
To use the appliance normally, set this
function to OFF.
°dF Hours
0 - 15 8
15 - 25 7
25 - 38 6
38 - 53 5
54 - 90 4
button to confirm.
USE - 85