Using The Safemode Gui; Accessing Safemode - SonicWALL SonicOSX 7 Getting Started Manual

From the SafeMode GUI, you can upgrade firmware, boot backup images and check the status of the
hardware.
NOTE: Unlike SafeMode on other SonicWall appliances, SafeMode is not a state in the NSsp; instead it
is a GUI available at all times. The appliance does not need to go into the SafeMode state in order to
access the SafeMode utilities.
Topics:

Accessing SafeMode

l
Rebooting the System
l
Upgrading Firmware
l
Diagnostics
l
Accessing SafeMode
AUX MGMT 1 Port
Access SafeMode at the management port for Blade 1 on the rear panel of the NSsp chassis. This requires a
cable to the top Aux MGMT port shown in the rear panel photograph see
IP Address
Access SafeMode at the management port for Blade 1 on the rear panel of the NSsp chassis. This requires a
cable to the top Aux MGMT port shown in the rear panel photograph; see
Address, see Check Network Address
.
(B1):65443
Login Credentials
When SonicOSX is running, only credentials with full configuration privileges allows access. If SonicOSX is
down, the Maintenance Key available for the product from www.MySonicWall.com, must be used.

Using the SafeMode GUI

Settings. Use this IP address with
SonicOSX 7 Getting Started Guide for the NSsp Series
Rear Panel.
Rear Panel. To find the IP
https://aux chasis ip
Using the SafeMode GUI
6
46