Table of Contents
Advertisement
Definitions
n Digit:
A digit is defined as any number from 1 to 9, inclusive.
n Valet code:
A valet code may be 1 to 3 digits:
A one-digit code=X=any number between 1-9
A two-digit code=XY=any number between 11-99 (excluding numbers with zeros)
A three-digit code=XYZ=any number between 111-999 (excluding numbers with zeros)
Remember, no code can have a zero.
n PlainView switch:
A rocker switch mounted on the dashboard or console. The
switch has three positions: 1.) Latched 2.) Centre 3.) Spring-loaded momentary.
When you press the latched side, the switch remains in its pressed position. When
you press the momentary side, the switch bounces back to the centre position.
n Entering a digit:
To enter a digit, you tap (press and release) on the momentary
side of the PlainView switch the number of times corresponding to the numeral of
the digit to be entered, followed by pressing to the latched side, then returning the
switch to its centre position.
n Entering a code:
If your code has only one digit, enter the code as described in
"Entering a digit." If your code has more than one digit, just repeat the above for
each digit of your code.
To enable valet mode
1. Turn the ignition switch to its "ON" position or start the engine.
2. Enter your secret valet code on the PlainView switch.
3. You now have 5 seconds to press the latched position to enter valet mode. The
system's LED will glow continually for on-going visual confirmation of valet mode.
To exit valet mode
1. Turn the ignition switch to its "ON" position or start the engine.
2. Flick the switch back to its centre position. The LED will turn off to confirm that the
system is now in its normal operating mode.
Remote controlled valet mode entry and exit
You can even enable or exit valet mode with your remote control simply by transmitting
channel 9 (LevelShift twice, then button 1). In addition to the above indications, two
side light flashes will confirm that you have remotely enabled valet mode, while a single
flash confirms exiting of valet mode.
Keyless entry in valet mode
Even if valet mode is enabled, you can still use the remote control to command the
system's convenience features. For instance, simply press button 1 (channel 1) as if you
were disarming and the doors will unlock (confirmed by one side light flash) and the
interior lights will turn on. Press button 1 again and the doors lock (confirmed by two
side light flashes). You can also use the other channels to start the engine and activate
options such as a remote boot release.
19
Advertisement
Table of Contents
