Table of Contents
Advertisement
How to remotely start/shutdown the engine
WARNING: Always exercise caution and common sense when using the remote
starting feature. Never remotely start the engine or engage the AutoStart feature when
the vehicle is parked in an enclosed area without adequate ventilation. Never allow
children to play with the remote control.
Whenever you remotely start the engine, the AvantGuard III rapidly makes a series of
safety checks before attempting to crank the starter motor. It will:
Verify that the engine or ignition switch is not already on.
Verify that the engine is not overheated.
Verify that no one is in the vehicle pressing the brake pedal.
Verify that the bonnet is closed.
To remotely start the engine, transmit channel 5 (LevelShift once, then button 1). All of
the following will occur:
You will see two side light flashes to confirm startup initiation. (NOTE: four
flashes indicate a fault condition, e.g., the bonnet is open).
The engine and all preset accessories (air conditioner, heater, defroster, etc.)
will start and run.
While the engine idles, the side lights will remain illuminated for on-going
visual confirmation.
When the engine is running under the control of your AvantGuard III, you may, if you
wish, shut down the engine by again transmitting channel 5.
Diesel compatibility
If your vehicle has a diesel engine, your AvantGuard III will activate the engine's
glowplugs for 20 seconds before actually starting the engine.
To drive the vehicle
1. Disarm and unlock the doors by pressing button 1 on the remote control. The side
lights will flash off once and the interior lights will turn on.
2. Enter the vehicle and close the door, but do not press the brake pedal nor move the
transmission out of park.
3. Insert your key and turn the ignition switch to its "ON" position (don't worry if you
turn the switch all the way to the "START" position; the system's StarterGuard
feature will prevent you from accidentally grinding the starter motor while the engine
is running under the AvantGuard III's control). The interior lights will turn off and, if
it is dark, the headlights will turn on.
4. Press the brake pedal. The system is now disengaged and your vehicle will operate as
usual.
NOTE: As an anti-theft measure, if someone presses the brake pedal or moves
the transmission out of park BEFORE turning the ignition switch to the "ON"
position, the AvantGuard III will immediately shut down the engine.
Remote Engine Starting
28
Advertisement
Table of Contents
