Extremely Important Notice; Warning - Clifford AvantGuard II Owner's Manual

EXTREMELY IMPORTANT NOTICE

If the AvantGuard II's control unit is removed from the vehicle for any reason, the
supplied RED jumper wire MUST BE CONNECTED to pins #8 and #11 of the
PIGTAIL connector.
1. The AvantGuard II is designed to be used only on a gasoline-powered, fuel-injected
vehicle with automatic transmission. If attempts are made to install the remote
starter on a vehicle with a manual transmission, the artificial intelligence of the
system will detect this and will render the system inoperative. The control unit
will not respond to attempts at reactivation and will have to be returned to Clifford
Electronics. There is a charge of $50 for this service.
2. If the vehicle is to be serviced, remove the 5-amp fuse from its holder connected
to the positive (+) terminal of the vehicle battery (leave the 30-amp fuse in place).
When servicing is complete, TURN THE IGNITION KEY ON, then firmly reinsert
the 5-amp fuse.
Always exercise caution and common sense when using the remote starter:
NEVER start the vehicle in an enclosed area without sufficient ventilation.
NEVER allow children access to the remote control.
NOTE: You must shift the transmission into DRIVE for at least 3 seconds if the
ignition has been turned on and off more then 10 consecutive times and/or
the engine has been remotely started more than 10 consecutive times.
Failure to do so will render the system inoperative.
C
ongratulations on your purchase of the Clifford AvantGuard II, the
world's most advanced vehicle security and remote engine starter
system. The AvantGuard II masterfully combines the state-of-the-art
in vehicle security with amazingly innovative remote engine starting fea-
tures to achieve the pinnacle in driver convenience, comfort and safety. Yet
despite the expansive wealth of stunning features, you will find the
AvantGuard II to be wonderfully user-friendly. Customizing the AvantGuard
II to meet your exact needs is as easy as a few flicks of a switch, but even
that simple effort is not required. The system comes from Clifford Electronics
completely preset and preprogrammed, so commanding it is no more difficult
than pressing a button on the Premier™ remote control.

WARNING

2