Unpacking And Mounting The Cintiq Interactive Pen Display - Wacom CINTIQ 21UX Installation Manual & Hardware Manual

Cintiq21UX_Manual.fm Page 9 Friday, January 28, 2005 6:49 PM

Unpacking and mounting the Cintiq interactive pen display

Do not remove the protective film from the front of the Cintiq 21UX interactive pen display until after it
has been mounted on the stand. Remove any packing materials from the back of the display unit and
cabling.
To mount Cintiq on the stand:
• Make sure the stand is stable on your desktop or other work surface and will not tip or fall when
Cintiq is mounted on it. Securely grasp Cintiq with both hands so that the display faces toward you,
with the power switch and LEDs located at the top.
Align Cintiq parallel to the front of the stand so that the bearing hub is located between the
V-shaped upper edges of the stand's bearing recess. See – A – (The V-shaped edges of the
stand will serve as a guide for positioning the bearing hub.)
• With the back of Cintiq resting against the stand, lower Cintiq until the bearing hub rests securely in
the bearing recess of the stand. See – B – on the following page. The display unit will be held in
place by gravity; there will be no audible 'snap' that indicates a mechanical lock.
Note: If you do not need to rotate the Cintiq interactive pen display, you may want to secure it to the
stand with the rotation lock screws. For information on this, see Optional display configurations on
page 53. To learn about other mounting options, see Using an alternate mount or stand on
page 54.
Bearing hub
– A –
Bearing recess
Unpacking your Cintiq
Page 9