Panasonic AG-DVC30P Service Manual page 224

3. Connect the Connection Adapter (VFK1763) to EVR connector in camera recorder. Then make sure that the
direction of the VFK1309A and VFK1763 are correct as shown in Figure.
When connecting VFK1763 to
the EVR connector, be careful
that it is installed in the correct
direction. Please follow as shown
in the figure.
4. Supply DC6V-9V to the Measuring Board (VFK1308P). Please use the DC cable (VJA0941) and AC Adapter to
supply DC voltage to Measuring Board.
5. Connect a 9 pin RS-232C cross cable between the Measuring Board and RS-232C connector on Personal
Computer as shown in Figure.
6. Unless otherwise specified on the message of the EVR software or this adjustment procedure, set the switches
on the Measuring Board as shown in the table below.
NAME
RS232C SEL (SW101)
VTR TEST (SW103)
BST TEST (SW104)
SW107
SW108
SW105
SW106
FLUSH1 (SW102)
FLUSH2 (SW109)
SETTING POSITION
D-SUB
NORMAL
NORMAL
CENTER position
H
H
OFF
NORMAL
NORMAL
ELE-3