Table of Contents
Advertisement
5 Installation Procedure
◆
Option LED Display
A - 1000-Series
LED Name
L.RUN
L.ERR
SD
RD
◆
Setting Station Address
Set F6-10 [CC-Link Node Address] to a station address (Range 1 to 64) unique to the network. If you set F6-10 =
0, the L.ERR light will turn ON and an AEr [Station Address Setting Error] will occur.
5
Installation Procedure
◆
Section Safety
DANGER
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized drive. Before
servicing, disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal
capacitor stays charged after the drive is de-energized. The charge indicator LED extinguishes when the DC bus voltage
decreases below 50 Vdc. When all indicators are OFF, measure for dangerous voltages to make sure that the drive is safe. If
you do work on the drive when it is energized, it will cause serious injury or death from electrical shock.
WARNING
Electrical Shock Hazard. Do not operate the drive when covers are missing. Replace covers and shields
before you operate the drive. Use the drive only as specified by the instructions. Some figures in this section include drives
without covers or safety shields to more clearly show the inside of the drive. If covers or safety shields are missing from the
drive, it can cause serious injury or death.
WARNING
Electrical Shock Hazard. Only let approved personnel install, wire, maintain, examine, replace parts, and
repair the drive. If personnel are not approved, it can cause serious injury or death.
WARNING
Electrical Shock Hazard. Do not remove covers or touch circuit boards while the drive is energized. If you
touch the internal components of an energized drive, it can cause serious injury or death.
WARNING
Electrical Shock Hazard. Do not use damaged wires, put too much force on the wiring, or cause damage to
the wire insulation. Damaged wires can cause serious injury or death.
WARNING
Fire Hazard. Tighten all terminal screws to the correct tightening torque. Connections that are too loose or too
tight can cause incorrect operation and damage to the drive. Incorrect connections can also cause death or serious injury from
fire.
12
Figure 4.5 Option LED Labels
Table 4.3 Option LED Display
Indication
Color
Display
ON
Normal operation
Green
OFF
Timed out
ON
CRC error
Red
OFF
During communications
ON
Sending data
Red
OFF
No data transfer
ON
Detecting data received
Red
OFF
Waiting for data
B - GA500, GA700, GA800
Operating State
Receiving data normally
• Timed out waiting to receive
• Logging onto the network
• During reset
• CRC error
• Station address setting error (F6-10 = 0 [CC-Link Node Address =
0])
• Normal communications
• During reset
Sending data
Note:
LED may appear to flash with slower baud rates.
• No data being sent
• During reset
Detecting data that was received
Note:
LED may appear to flash with slower baud rates.
• Data not yet received
• During reset
YASKAWA SIEP C730600 83E CC-Link Technical Manual
Description
Advertisement
Table of Contents
