Bosch MIC IP fusion 9000i Installation Manual page 17

MIC IP fusion 9000i
Mounting surface recommendations for MIC mounting accessories
The mounting surface should be capable of supporting the combined weight of the MIC
camera + MIC Illuminator + MIC mounting accessory (DCA, wall mount, corner bracket, etc.).
All expected conditions of load, vibration and temperature should be considered when
planning an installation. The material should accommodate a minimum pull-out strength of 275
kg (600 lb).
The mounting accessory should be secured to one of the following surfaces:
–
–
–
–
In all situations, Bosch recommends referencing any applicable building codes or professional
structural engineering guidelines for a secure installation.
4
Caution!
Risk of lightning strikes
If the camera is installed in a highly exposed location where lightning strikes may occur, then
Bosch recommends installing a separate lightning conductor within 0.5 m (1.6 ft) of the
!
camera and at least 1.5 m (4.9 ft) higher than the camera. A good earth bonding connection
to the camera housing itself will provide protection against damage from secondary strikes.
The camera housing itself is constructed to cope with secondary strikes. If the correct
lightning protection is applied, then no damage to the internal electronics or camera should
result.
Installation in a damp environment (for example, near a coastline)
The fasteners shipped with the camera are designed to resist corrosion. Always use Bosch-
supplied screws and other fasteners when installing the camera.
The camera head has factory-installed plastic screws that prevent corrosion in the screw holes
when no MIC sunshield accessory is attached. Do not remove these screws until you install a
sunshield accessory. For complete details, refer to the installation instructions for the
sunshield accessory.
Before installation, inspect the metal parts of the camera for paint that is chipped or
otherwise damaged. If you notice any paint damage, touch up the damage with paint or
sealants available locally.
Avoid installation practices that may allow the camera's metal mountings to contact materials
such as stainless steel. Such contact can result in galvanic corrosion and degrade the
cosmetic appearance of the camera. These cosmetic damages caused by improper installation
are not covered by warranty as they do not affect the functionality of the camera.
Bosch Security Systems
Concrete (solid / cast)
Concrete masonry unit (concrete block)
Brick (all types)
Metal (steel / aluminum, minimum 3 mm (0.125 in.) thick)
Ensure that the selected mounting surface is capable of supporting the combined weight
of the camera and mounting hardware (sold separately) under all expected conditions of
load, vibration, wind, and temperature.
Installation Manual
Mounting | en
2022-09 | 1.6 | F.01U.334.820
17