5G Pluggable Interface Module - Cisco Rugged Series Installation Manual

Product Overview
1 Main 0 Antenna
2 Diversity 1 Antenna
3 Diversity 0 Antenna
4 Main 1 Antenna
P-LTEAP18-GL Frequency Bands
The following table provides the global frequency bands available.
Note
Item
MAIN 0 and DIV 0
MAIN 1 and DIV 1

5G Pluggable Interface Module

The 5G Sub-6 GHz Pluggable Interface Module offers 5G capability to the IoT Industrial Router family. The
product ID for the pluggable module is P-5GS6-GL. The P-5GS6-GL uses the FN980 Telit modem.
Note
The following features and limitations apply across all IoT routing platforms unless specifically mentioned:
• IoT routing platforms support a maximum of two pluggable modules, with a combination of 5G and 4G
• The pluggable module can be started or stopped through the CLI under exec mode. Also, it can be
• The capability to disable FDD Band 30 for vehicular applications is available.
The following figure shows the P-5GS6-GL pluggable module:
5 Enable LED
6 SIM 0 LED
7 SIM 1 LED
8 RSSI LEDs
Antennas must be attached to the RF connectors as listed below for proper bands service.
Description
B1, B2(B25), B3, B4(B66), B5(B26,B18,B19), B8, B12(B17), B13, B14, B20, B28,
B29, B39, B71, B41
B7, B30, B32, B38, B40, B41, B42, B46, B48, B2(B25)
IOS XE release 17.8.1 is the first software release to provide support for the P-5GS6-GL on IR8340 router.
PIMs.
configured to power off the module to reduce power consumption as needed.
Cisco Catalyst IR8340 Rugged Series Router Hardware Installation Guide
P-LTEAP18-GL Frequency Bands
9